V+ remote control codes

Click on the button below to download the V+ remote control codes document

To set volume control on your V+ remote, please find your make of TV and the codes that match it and then follow the following instructions. There may be multiple codes shown for your make of TV. If so, you may need to try more than one code before your remote is successfully re-programmed:

• Now that you have your three digit code, add a 0 (zero) before it. This now makes a four digit code.
• Press and hold down the 'Vol +' and 'Mute' keys on your remote at the same time for at least three seconds, until the red light in the top right-hand corner of your remote control flashes twice.
• Release the buttons and enter the first four digits from the list of remote control codes (you must do this within 10 seconds of the red light flashing).
• As you enter the first three digits the red light on your remote control will give a short blink.
• As you enter the fourth digit, the red light will flash twice to confirm that the volume is set.
• If the setting of the volume is not successful, please repeat the above steps with the second/third/fourth etc codes from the table.
• If the volume control is still not working after trying the codes for your TV model, or your TV is not listed, then your TV is not compatible with our remote control and you will need to use your TV remote to control the volume of the TV and your V+ remote to control the volume of the V+.